Exhaust Pipe installation of Belief diesel stove heater
During the installation of the belief 2.2kw diesel stove heater, for more details of the stove heater, pls click the link to find more in the page. Even we provide the installation manual in details, but for those 1st to use it, there are some points that we should take note ahead, especially the installation of the filter and exhaust pipe. As we know, the diesel stove is usually used to cook and heat the water, coffee on the motorhome, it works by diesel, after the burning of the diesel in the burning chamber, the exhaust gas needs to be discharged outdoors through the exhaust pipe. Obviously, the exhaust gas is harmful to body and the pipe is very hot during work. So, we need to install them outside of the car, that is definitely no doubt.
Where to install the exhaust pipe
The best position will be the bottom of the car outside, just like the place of the exhaust pipe of the motorhome, Please refer to the installation location in the attached picture. It is just a suggestion, due to the different design of the car, customs will have their best plan, but as least you can consider it. But be sure, DO NOT install the pipe on the side of the car, that would be very dangerous during the operation. Especially when people passes by, they would easily get burned.
the diameter of the exhaust pipe for belief diesel stove is: 25mm.
How to install the exhaust pipe
Before the installation, we may need to do the following preparations. First we need to drill a hole on the floor of the car, the size of the hole is suggested a little bigger then exhaust pipe, diameter of the hole at 26mm will be perfect, Second, before installing the pipe, it is very very necessary to wear this Insulation sleeve on the exhaust tube, the exhaust tube is very hot during operation, there may be floors inside the motorhome. Without the Insulation sleeve outside, it may cause fire and damage to the floor. For the safety reason, we specially include it to come with the installation kit. No.17 in the left attached installation drawing is the Insulation sleeve. It is put on the exhaust pipe and passed through the vehicle floor to prevent the exhaust pipe from contacting the vehicle floor.
At last, After installation, please don’t forget to a good job of sealing. Hope the above will help you. If any more questions, don’t hesitate to contact us.
